Section 7 - Rudder (riveting everything together)

Lots accomplished today, much of which was riveting.  This post will be mostly pictures, with only a few words, since I'm pooped from almost 8 hrs in the workshop.  All the parts preparation the last week or so made today just knocking out the riveting tasks one-by-one.

Back-riveted stiffeners to rudder skins and and blind-riveted stiffener clips to right rudder stiffeners:

Section 7 - Rudder (new bench/shelf; trailing edge; priming)

I needed a little more storage for the large flat and odd-shaped  pieces in the empennage kit (the floor wasn't working), so a fellow builder (Ken B.) recommended 2x4basics (Amazon) to create a 4'x8' bench/shelf.  He uses this setup for the wings (large) in lieu of the EAA workbenches.  I'm using it for storage, at least for now - thanks for the suggestion, Ken.

Section 7 - Rudder (trimming; initial assembly; drilling trailing wedge)

The rudder is making the vertical stabilizer seem like child's play.  Lots of little parts that all need to be separated and trimmed down to their final shapes.  Skins are VERY thin (0.016") and feel like they will bend/break when I move them around.  Tons of rivets in the skin as well as lots of LP4-3 (and other) blind rivets to zip the entire assembly together.  Amazing engineering though; I like the lead weight used as a counter balance.  For those of you, whom have flown an RV, that smooth feel of the control surfaces is due in large part to well-matched counterweights.

A few pictures from this part of the build are below.